Author Topic: Verify Failure - Error Code 9  (Read 1417 times)

Offline pbrauman

  • Full Member
  • ***
  • Posts: 108
  • Karma: +1/-0
    • View Profile
Verify Failure - Error Code 9
« on: January 04, 2014, 04:42:37 am »
Hi,

Getting a verify failure.

1. What does error code 9 mean?

2. The failure is for UOR position 5 and UOR ID = 10001. How can I tell which disk this is?

Thanks

Offline dscline

  • Sr. Member
  • ****
  • Posts: 272
  • Karma: +6/-0
    • View Profile
Re: Verify Failure - Error Code 9
« Reply #1 on: January 04, 2014, 07:29:24 am »
I don't know about error code 9, but UOR position 5 should be the 6th disk in your list.  It starts at 0.
WHS 2011
tRAID final 23 DRUs 2PPUs
Supermicro C2SEA, Q9505s (stock), 4GB
Supermicro AOC-SASLP-MV8
IBM m1015 flashed to LSI 9211-8i/IT + HP SAS Expander
Generic SiI3132

Offline Brahim

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 8,547
  • Karma: +204/-16
    • View Profile

Offline pbrauman

  • Full Member
  • ***
  • Posts: 108
  • Karma: +1/-0
    • View Profile
Re: Verify Failure - Error Code 9
« Reply #3 on: January 04, 2014, 05:08:05 pm »
Thanks for the answers. 

Would it be correct to assume then that the PPU is the cause of the error? If so what would be an appropriate recovery action.



Offline Brahim

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 8,547
  • Karma: +204/-16
    • View Profile
Re: Verify Failure - Error Code 9
« Reply #4 on: January 04, 2014, 09:29:31 pm »
No. Only negative value error codes are actual disk or system errors.
This error code is the number of failed bytes.

This is not a big issue. Just run the Verify & Sync operation.