Author Topic: Can't run Verify & Sync  (Read 719 times)

Offline Method007

  • Newbie
  • *
  • Posts: 31
  • Karma: +0/-0
    • View Profile
Can't run Verify & Sync
« on: December 26, 2015, 01:47:57 pm »
I just added two 4TB HD's to my array.  After replacing the place holder drives, I rebooted and started the array. The new HD's space did not show up in the array.  I read on this forum the next steps to take, i.e., turn off array, create volume on the newly added drives, restart array and run verify and sync.  I added the volumes then restarted the array.  Now when I click on verify+ or verify sync I get the error "The device for which the operation was requested was not found!".

The only drive not showing up in the array list is the first drive I added, Volume 10.  The place holder is also gone however.  Anybody have any advice?