FlexRAID Support Forum

FlexRAID™ RAID over File System (RAID-F™) => Real-Time RAID => Topic started by: Method007 on December 26, 2015, 01:47:57 pm

Title: Can't run Verify & Sync
Post by: Method007 on December 26, 2015, 01:47:57 pm
I just added two 4TB HD's to my array.  After replacing the place holder drives, I rebooted and started the array. The new HD's space did not show up in the array.  I read on this forum the next steps to take, i.e., turn off array, create volume on the newly added drives, restart array and run verify and sync.  I added the volumes then restarted the array.  Now when I click on verify+ or verify sync I get the error "The device for which the operation was requested was not found!".

The only drive not showing up in the array list is the first drive I added, Volume 10.  The place holder is also gone however.  Anybody have any advice?